[SkyFire]

Finally finished the 3rd ring of the body frame. Sensors have been added to detect the rotation of R2D2's dome.

[SkyFire]

Added some arms to R2D2.

[SkyFire]

Added the final body panel. More parts still to be added to the body panel though and they will have to be removed for more work on the body frame.

[SkyFire]

Final body panel is all finished.

[SkyFire]

More framing added to the dome. Think it will have to be removed, to add more electronics at some point in the future.

[SkyFire]

Final body panel fitted to the frame with on / off switch and charging jack. Body panels may have to be removed at some point in the future to allow more work inside the frame, but for now it is easier to have them attached.

[SkyFire]

Started on the centre foot, this will take a little while to get done, then back to the body.

[SkyFire]

More work on the centre foot. For now the foot is just resting in place and has not be screwed together.

[SkyFire]

R2D2 has legs!!! I just had to see what it looked like with the panels attached and the dome in place.

[SkyFire]

The start of the electronics.

[SkyFire]

R2D2 now has a brain installed, but not connected up yet, that happens much later.

[SkyFire]

I need to redo the wiring in R2D2 and make things a lot neater before plugging things in, just hope I can get the plugs out without damage. It would have been nice to have the information about routing wires before the information about plugging wires into places! Decided to keep R2D2 as a static model, so it doesn't matter if the wiring is no good or not. Therefore, for all intents and purposes, it is finished!

Here we go, effectively all finished as a static R2D2.

SkyFire,