[SkyFire]

Upper left trim panel has been installed. Next up is the Rear cabin partition.

[SkyFire]

Finally another update and the rear trim sections have all been added. Next up is the roll bar and seatbelts.

[SkyFire]

Rear seat and rollbar are now in place. Did the rear seat before adding the rollbar as it made it easier to hold the rear seat in place while I added the four screws to attach it to the floor.

[SkyFire]

Finished the area behind the back seat and built the steering column. Pressing the logo sounds the horn.

[SkyFire]

Inside section of the car has been screwed to the chassis. Had to remove the steering pinion to get the steering wheel in place.

[SkyFire]

Latest photos of the Mustang. Radiator is 2/3rds done and won't stand up yet. Not sure what will holds it in place right now.

[SkyFire]

The radiator is finally complete, next up is the front of the engine.

[SkyFire]

The front of the engine with the radiator.

[SkyFire]

An update on the engine now I have both halves. Lots more bits to be added though.

[SkyFire]

Engine sitting in roughly the right location in the chassis.

[SkyFire]

Update for the engine.

[SkyFire]

Added the distrubtor and coil to the engine. Also added the oil sump to the bottom of the engine.

[SkyFire]

Latest bit of work on the car. Engine is now attached to the chassis.

[SkyFire]

I now have the righthand side and rear panels in place around the engine minus the righthand shock absorber spring. Panels were not ligning up with the sping in place, which tells me the spring is probaly too long. Can't be bothered trying to change things!

Update: I had another go at things and the spring is now in place.


All panels are now in place with springs both sides.

[SkyFire]

The car gets some electronics, this is to control the sound and light functions in the model.